I have a board from flyduino with the correct labels on the back, but I am having problems getting v 2.2b uploaded to the board. 2.1 works fine, but after uploading 2.2b the board does not boot up (red led, but no green comes on) and the GUI cannt connect.
Hi Alex - yes I have, Paul offered to flash the firmware if I sent the device back. I wanted to see if there are other ways so I don't have to send stuff back and fowards.
BTW - I am really looking forward to get this working, you have the best 3 axis solution out there, especially with the Follow Mode!
I had the same problem, when setting up the Alexmo fromFlyduino (Win7) GUI said, it´s 2.0b3 loaded and it did not work with newer GUI-version (2.1, 2.2)
Finally I got it to work by followin steps: - Uploading 2.1 via Xloader (checked the Firmware in GUI) - Uploading 2.2 via Xloader (Xloader sais "Uploade failed) but FUI finally accepted the Board and showed 2.2