Im having a bit of trouble getting my mac to see the controller with the Simple BGC software. Im running a CM2000 with at Phantom & using v.2 software. I have done (ithink) the terminal corrections that were specified in the set up but... how do i know that worked?
Sorry not much of a programmer just fumble my way through usually.
I installed Silabs, FTDI and follow the recommended steps in Terminal to make folder, change permissions and allow to run non-signed apps in System Preferences… SimpleBGC software looks running good, but the COM port doesn't appear…
I connected the board to a PC, and upgrade the firmware to 2.40 …no problem at all… 5 min!!! Then I connected the board to my mac but no COM Port appear, instead I have selected one called "/dev/cu.SLAB_USBtoUART" …I don't know if that can be a problem… but the thing is everything is responding when I move the sensor...