EN CN
How to flash new firmware
  • DangerD
    I have BGC-V3.15 2014-02-27
    http://files.dangerd.org/pub/BGC/IMG_20141109_191121.jpg
    In manual (XLoader): Leave all other settings at default (baud is 115200, device is "SimpleBGC").
    I don't have SimpleBGC in device list, only: Duemilanove/Nano(ATmega328) and Uno(ATmega328)
    After hitting upload, Xloader stucks with Uploading...

    Also link for Xloader on this site is dead.

    Now controller is bricked.
    Any other manual how can i recover it?
  • AndrewSupport
    Hello, Please, contact your seller to find out the controler manufacturer and let us to know.
  • robydriver63
    Hello , I also do not find an indication of a flash pin . How did you solve it?
    thanks aid
  • Leon33
    Hi, Try to download (8 bit) GUI version: 2.40b7 + firmware with it
    -Connect the board to your PC via USB. Red light has to light up on the board.
    -Start GUI and do the following steps:
    Select appropriate COM port. Do not press button "Connect".
    Open TAB "Firmware Upgrade"
    Specify location of Firmware HEX file -> " SimpleBGC_2_40b7.enc.hex"
    Press button "Flash".
    Wait until uploading to be finished.
    Unplug USB ...and then plug again

    Remember: if Your board does not have any flash pins then you won't be able to flash to newest firmware due to flash pins that are needed in re-write process....so stay with that older version
  • mph621
    How do you select the com port?
Add a Comment