Klaus

Where do I find the information on how to setup S-BUS of my 32bit Basecam Board to a DJI A2
A2 has an internal DR16 receiver which it uses. In the A2 manual when you look on page 7 (A2 image) and page 9 (C. S-BUS Receivers) the S-BUS signal is at X2. I have not splitter the S-Bus cable I went straight from Basecam Board to X2 and use the…

Comment by Klaus November 2014 permalink
Where do I find the information on how to setup S-BUS of my 32bit Basecam Board to a DJI A2
Thanks Garug; yes, the X2 connector at the A2 is for S-BUS connection. But are my settings at the SimpleBGC GUI correct as shown?

Comment by Klaus November 2014 permalink
Firmware Upgrading - Failed to upload: Error writing firmware: Flash tool execution failed (1)!
I have a problem with this seller. He agrees that I can sent it back and they will check and fix it, but they want me to pay half of the shipment costs although the gimbal is brand new and never worked. Really very poor service for a kickstarter pro…

Comment by Klaus August 2014 permalink
Firmware Upgrading - Failed to upload: Error writing firmware: Flash tool execution failed (1)!
Thanks alexmos, I asked the Gimbal manufacture (in US and I am in Europe). They confirmed it's the 32bit board and 2.41b4 would be installed. I only did try the manual downloading (as the automatic doesn't work as well) Firs I tried with …

Comment by Klaus August 2014 permalink

Howdy, Stranger!

It looks like you're new here. If you want to get involved, click one of these buttons!

Sign In Apply for Membership

About

Username: Klaus
Joined: August 2014
Visits: 9
Last Active: August 2015
Roles: Member

Powered by Vanilla