Tasz

Motors will not start immediately after switching on controller
Yes that's right My transmitter works perfect with the alexmos. Only the motos wont start up immediately when i set CMD to profile 1,2 or 3 :(

Comment by Tasz April 2014 permalink
Motors will not start immediately after switching on controller
Why do I not have problems with 2.3? Do you use a graupner gr16 receiver? I think it's the combination 2.4 and graupner

Comment by Tasz March 2014 permalink
Motors will not start immediately after switching on controller
Yes low 1109 high 1912 I think its a bug because in 2.3 I had no problems with the same settings

Comment by Tasz March 2014 permalink
Motors will not start immediately after switching on controller
On what profile does it start (if CMD (no input) or is set LOW on "no action") .... Profile 1 Is the CMD level sent at the start LOW? what if it is MID or HIGH? ... I try on start LOW MID and HIGH. Doesn't work What if you assign so…

Comment by Tasz March 2014 permalink
Motors will not start immediately after switching on controller
Unfortunately it does not work The strange thing is if I do not assign the CMD (no input) or is set LOW on "no action" , then start the engine immediately But when i set LOW on profile 1, then dont start de motor's

Comment by Tasz March 2014 permalink
Control Pitch & Yaw on alexmos board
solder jumper L1

Comment by Tasz March 2014 permalink
Motors will not start immediately after switching on controller
yes im sure I think its a bug because the new firmware 2.4b7 says "Sum-PPM input (FrSky and may be others 8-channel) was conflicted with PWM inputs from flight controller" I have my joystick conectet on the FC input I think this is th…

Comment by Tasz March 2014 permalink
Yaw using a RC Radio
No, you can use fc-roll or fc-pitch input for the yaw It's possible to use 3 inputs

Comment by Tasz March 2014 permalink
Yaw using a RC Radio
You can assign fc-roll to the yaw. Or use ppm-sum

Comment by Tasz March 2014 permalink
Motors will not start immediately after switching on controller
No i dont. Ch 5 = CMD LOW = Profile 1 MID = Profile 2 HIGH = Profile 3

Comment by Tasz March 2014 permalink

Howdy, Stranger!

It looks like you're new here. If you want to get involved, click one of these buttons!

About

Username: Tasz
Joined: March 2014
Visits: 43
Last Active: April 2014
Roles: Member