Hello Gwen,
I have read your threat about the Lightbridge D-Bus issue. Thanks a lot for this valuable information.
I do have the same configuration A2 - Alexmos 32bit - Lightbridge.
But before even bringen Lightbridge into this game I have already a problem with the S-Bus configuring to the A2. I don't have much experience and the information in the BGC and A2 user manual does not help me further.
How do I set-up SimpleBGC GUI and A2? I connected RC-Roll from the Alexmos board with X2 at A2 (only 2 wires GND and signal)
Set in the RC Tab of the SimpleBGC GUI,
- RC_ROLL pin mode to Futaba s-bus,
- ROLL to "no input",
- PITCH to "VIRT_CH_11"
- YAW to "VIRT_CH_12"
- CMD to "VIRT_CH_14"
- FC-ROLL to "VIRT_CH_13" ?
When starting the A2 assistant software I don't see anything. Do you have any information or link which can gel me further,
Many thanks
Klaus
November 2014