we've currently bought a set with an extended controller, motors and encoders from iflight (https://www.iflight-rc.com/index.php?route=product/product&product_id=252) through an german dealer. Now I'm trying something desperate to set up the encoder. The encoders are connected with the six pin cables and in the software the encoder type is set to AS5048A (SPI) with 1MHz.
If "skip autodetection" isn't set, the electronics already fall into a litany of peeping when switched on. However, if it is set, the electronics starts but no values appear in the monitor, the encoders can not be calibrated and the read errors are counted up in the debug.
Do I overlook something or is the electronics broken? I would exclude the encoders, because there are all three of them which I get no data.
I've never worked with encoders before and my dealer is unfortunately unwilling to help me.
Hello, I found similar motor from Iflight with built-in encoder, and discovered there AS5048L This is clone of AS5048A chip is compatible with our boards. But sequence of pins in the connector is different from sequence of pins in our controller. This photo with description will help you connect the encoder correctly: http://ybex.com/d/q3uhyb1tzgsda23jecy4hlfk7pbdyb244g6zxthv.html
i have problem like similar discuss . i also have problem from iflight encoders and alexmos board , i bought controller board version extended . when i read your messages i see you put the link address for photo : http://ybex.com/d/q3uhyb1tzgsda23jecy4hlfk7pbdyb244g6zxthv.html .
when i tried to open this photo doesn't work . could you please let me use the conection diagram of iflight extended board with AS5048L ??