Help ! I have v2.40 b7. Works perfectly & love the ability to configure, especially follow yaw & ability to avoid getting legs/blades in shot.. My problem !!!! Motors are OFF by default, when I power on the gimbal. The only way to get motors on again is to connect to GUI & manually turn motors on. I have tried writing config, with motors on. I have tried flashing firmware again & re-writing settings. Does anybody have any suggestions please?
Resolved.... I had "Low Voltage - Stop Motors" set at 11v & my battery was less. Silly mistake. It made it difficult to diagnose whilst I was feeding voltage to the board through the usb connection. Thanks for your suggestion Garug.