I have been searching for some answers as I get started working with my gimbal controller.
Previously, I went to update and it seemed as though my card was an 8 bit, although it appeared to be the 32 bit. In any event, it allowed me to update the 8 bit firmware, which I did to the latest.
Now, when I go to connect, it says GUI/Board type mismatch. Is there a way to confirm which firmware version is on this now?
Secondly, when I plug this into power, I get the loud buzz. I didn't see that this reflects an error - what does this mean? The LED indicator is solid. When I power it up, it doesn't go through the initial startup sequence either. Power is connected as well as my gyro, pitch and roll connections.
Looking again, it is definitely 8 bit. I know I upgraded the firmware to the 8 bit 2.40b7. Either way, I can't connect with that GUI now - or, any other 8 bit GUI.
I was hoping that by connecting to the GUI, I could figure out the loud buzzer issue!