Hello. I ran into a strange problem, I am running the latest beta firmware on my handheld gimbal (32bit alexmos board). It was running without any hickups and I was in the process of tuning it since I recently redesigned my rig. Then I was out of curiosity mocking about with the analyse tab, not knowing really what it does. I then hit analyse and the GUI told my to change my baud rate to 256000. After I did that, I lost all connection to my board and am unable to regain it. I have tried bluetooth and USB connection and restarted both gimbal and computer but still no change. Anybody know what I am up against?
I might add that the gimbal is operating normally, I just can't connect to it anymore. best regards Runi.
did the same thing but i cannot cat it back to work. I dont have a usb anymore (broken) Hou cane i connect to the software to set the bitrate back to 115200?? Please help!!!