HI. I am a newby to these gimbals and hope that someone on this forum may be able to help me. My new DYS gimbal worked fine out of the box. I flew it and noticed a roll wobble. I hooked it up to the GUI and the unit has gone crazy. The accelerometer will not calibrate. I tried the 6 axis calibration as well. same problem. When I disengage the motors it stops. The shaking alters when I enter new PIDs but it will not stabilize. I'd appreciate some guidance or a magic bullet solution. Cheers. Vladimir.
Hi. Thanks for the response. I try to. The message keeps saying that the accelerators need calibrating. I even tried the 6 axis calibration but no result. I will check the video of the 6 axis calibration again and throw myself into it...... again. Regards. Vlad.
HI. When you say sensor orientation I take it you mean the IMU? I also note to point Z axis parallel to motor but it does not make sense to me. I'm somewhat a newby. A clarification would be great. Look forward to the screenshot. Thanks. Vlad.
HAHa. My sensor directions were wrong. I input Axis TOP = X RIGHT -Y and it stops spazzing out. Pitch looks good. Roll has some problems. Almost there. Now I need to play with the PIDs
Hi. It rained all day yesterday, so no flying. Small window today. GOPRo battery died after 1 minute ( stupid boy) but here is it.
I am getting vibration that I think comes from unbalanced props. But the serous wobbles start about 50 seconds in to the video. My PIDs are Roll: 7 0.1 6 Pitch: 6 0.4 6 Yaw: 10 05. 10 Any guidance or suggestions on vibration are welcome.