For RC control on the 32 bit board we have it hooked up and powered from a outside battery source. to get power out of it directly at the rc roll/yaw pins do we need to bridge anything or solder anything on the board? Have tested and cannot get power out of pins Devin
On 8 bit board I needed to solder the JP1. This probably is board specific even among the 32 bit boards. Did you not get any instructions with your board?
Hi Devincard. Could you explain what you did, please? I have the same issue. No power to the motors. I ordered 2 through flyduino, they only sent one IMU and one of the boards was missing components. I am trying to figure out if the second board is also faulty or if I haven't done something I am supposed to. I can hook up to the software blah blah but I get no love with powering the motors. Confusing. Thanks