Hii all… I’m trying to configure the 2 axis brush less gimbal to control with the mavlink. When i powered the gimbal it’s it’s moving. I connected the Go Pro to the gimbal and tried to control with the RC but I’m not able to control the Gimbal. Later i get to know I need to configure some settings for the Gimbal by using the Simple BGC GUI. I installed the GUI and when i trying to connect with the GUI to Gimbal It’s not connecting and showing the Error Firmware Version and GUI Version is not matched. I tried to upload the 2.4 version firmware into the Gimbal controller board by using X loader software but it’s showing that uploading is failed.
If anyone have solution for this problem please let me know the steps how to solve this error…
You could probably download an older version of the GUI, it has to be the same version of the firmware. For 32bit boards the older version go back to 2.40b8.