I would like control those 2 axis on my alexmos board v2.3b5 firmware. I'm using a 3S battery.
When I plug a servo tester or a 3 channel receiver on RC_Pitch, RC_Roll, FC_pitch & FC_Roll, it seems there is no power on those pins, like if there were not activate.
In the RC control of the software, I select RC_Pitch analog when I plug the servo tester and PWM when I plug the receiver.
I got same issue, thanks Tasz!, I figure it out.Now ok. Dear Jonathan311 , there is 2 spot near sensor pin on the main board wrote L1 , just solder it.