EN RU CN
How to setup for single axis operation (roll axis)
  • Hello,

    I am new to this forum and have a question re single axis operation.

    I am wanting to setup using just one motor for the roll axis only. I seem to have it operating OK but the LED is fast blinking, meaning stabilization cannot be performed.
    I wonder if that is because I have no pitch motor connected?

    I would appreciate any advise.
    Thank you.

  • Hello,
    To set system to single axis mode, just disable 2 unused motors in the "Hardware" - "Motor outputs".
    If LED blinks, connect GUI and check the error (shown in red color at the bottom). Also, "Debug" - "Request system state" may give some information about the problem.