EN CN
Not levelling on startup
  • ssb2005
    Hi

    I have a 32 bit board mounted to a multi rotor with 2 axis gimbal.
    When I use the 2.60b4 firmware it will not level on boot up. It will hold its position, I can move the camera to level with my hand and it will hold the position it is left in. I have tried setting the button to level pitch and roll but it does not bring the cam level.
    If i switch back to 2.56b7 it levels on startup automatically.
    I have recalibrated the IMU's and tried an EEPROM erase and still no joy.
    Any other ideas?
Add a Comment