Hi I accidentally erase the factory profiles from my Ikan DS1 beholder and cannot re-configurate it anyway, tried many tutorials. Now it's unusable.
I install simpleBGC v2.56 b7. And now I'm trying with Firmwire v2,56b7 too. Erased EEPROM. Calibrated Camera IMU and frame IMU with 6 points, loaded some "deafult" profiles someone shared to me. They seem to be OK.
I found a really strange issue. In the Motors Congifuration panel, when I press Auto everything works fine, except from the Inverted marks. All the tutorials I found on DS1 shows that PITCH is inverted and YAW & ROLL are not inverted.
although, in my case, after the AUTO option, PITCH is not inverted and YAW & ROLL are inverted. If I WRITE this to the gimbal, it works but with really weird shakings and wrong behaviour. If I switch PITCH to inverted, and YAW & ROLL uncheck the invert option, and WRITE: then the behaviour is even worse.
I would really appreciate any advice on how to get back my gimbal to the factory behaviour. I'm really struggling but with no results yet.