All Discussions - Brushless Gimbal Forum

GPS IMU - I would like more detail please

1 comment Started by NavigatorDecember 2020Serial API

1-axis gimbal slowly follows frame, but shoud not

3 comments Most recent by aeromap12November 2020Tuning brushless gimbal

Beholder MS-1 Factory original profiles.

3 comments Most recent by NikolaiNovember 2020Troubleshooting

SimpleBGC_GUI 2-axis lights but nothig else

1 comment Started by CarlosAncaresNovember 2020Troubleshooting

Procedure of encoders calibration

4 comments Most recent by Franze8791November 2020Troubleshooting

G10060 BGC PRO

3 comments Most recent by bitOctober 2020Motors

Brushless gimbal configuration with Mavlink (Pixhawk 1 autopilot)

7 comments Most recent by mohseinOctober 2020Serial API

Controlling encoder enabled gimbal over Mavlink and simultaneous using FC as external IMU

2 comments Most recent by ronsandOctober 2020Serial API

SYSTEM_ERROR 16 (ERR_PROTECTION) on BGCExtended v2.70 b0 with Encoders

1 comment Started by jcobrerosOctober 2020Serial API

Improve behavior of follow yaw

3 comments Most recent by Franze8791October 2020Troubleshooting

Android app for firmware 2.70b0

3 comments Most recent by ronsandOctober 2020Tuning brushless gimbal

H2 no longer working properly since firmware update

12 comments Most recent by JohnsonOctober 2020Troubleshooting

Software won't connect...

10 comments Most recent by JohnsonOctober 2020Getting started

sorry I'm trying to delete this post

2 comments Most recent by echidnaOctober 2020Tuning brushless gimbal

4-wire motor: how to connect?

1 comment Started by gedasOctober 2020Motors

Timelapse goes the opposite direction

1 comment Started by nongrata23October 2020Getting started

SimpleBGC 32bit - can't flash firmware

1 comment Started by Curtis7990October 2020Troubleshooting

Gyro data is totally out of WHACK

2 comments Most recent by JinhoMinOctober 2020Troubleshooting

Power too low for motors

3 comments Most recent by JinhoMinOctober 2020Getting started

Mavlink connection - problems

1 comment Started by DLabSeptember 2020Troubleshooting

CameTV Argo - Remote control Button no longer switching profiles

2 comments Most recent by samraby512September 2020Troubleshooting

Came tv 7800 gimbal

3 comments Most recent by samraby512September 2020Getting started

Discussion about this forum

3 comments Most recent by AndrewSupportSeptember 2020Software (ideas, feature requests, bug reports)

My PilotFlyAction-1 controller died, can i order same model?

4 comments Most recent by sergiodroneSeptember 2020Troubleshooting

Pilotfly H2 Eeprom Profiles HELP!!!

3 comments Most recent by DjOMARiSeptember 2020Troubleshooting

SimpleBCG32 as advanced servo controller

2 comments Most recent by alexmosAugust 2020Getting started

Two axis stabilizer - pitch/roll - question

3 comments Most recent by adrianniAugust 2020Tuning brushless gimbal

Motor continue to spin and does not go back to zero

2 comments Most recent by AndrewSupportAugust 2020Electronics

Booloader

1 comment Started by mgrimes3406August 2020Troubleshooting

3-axis IMU

1 comment Started by vasanthkyAugust 2020Getting started

Howdy, Stranger!

Categories