I had it working great for a day or two. I was plugging the usb in to the board and accidently touched the exposed pins for 3rd axis. It blew up the f9335 IC. I replaced the IC but still no green light. Anybody know what the voltage should be out of the A7 diodes?
I didn't mention that there is no board function in the GUI and it won't re-flash. I get this message... avrdude: stk500_getsync(): not in sync: resp=0x00
Guess it's dead. I tried the other FDTI port with the Sparkfun thingy. Either way when I connect in GUI it recognizes the comm port but only says connecting and doesn't finalize the connect. If I try and flash the firmware the GUI then display changes to Disconnected rather than Connecting. Must be the SiLabs IC.
No, it's suddenly turned no green light & board not recognized when connect to Simple BGC controller. It's happen just last night when setting up the PID. So strange.... Do you have any solutions?