Hi. I am planning to use trigger function (like in example program from Scripting language PDF) but i don't understand - what type of signal i receive on AUX1 when trigger will active?
When trigger set to "0", what i have? And when trigger set to "1"?
If AUX1 is the port for the Trigger function and it's NOT used for something else... "0" means that the AUX1 signal pin is set to the OFF/LOW state (GND/0V) "1" means that AUX1 signal pin is set to the ON/HIGH state (+5V or +3.3V)
Hi, You can set any RC pin or Aux pin to 0 state (low, or GND) or 1 state (high, or +3.3v). Current is limited by 20mA, so this output can be used only to drive logic.
If you want to control servo or something like RC IR-camera shuter, use SERVO command instead.