I use a CAME 7000 3 axis gimbal with a 3 axis 32bit AlexMos controller ( SN=0123633156cb2517ee - firmware= 2.42b7 ) I use SimpleBGC GUI v2.42b7. I have installed the joystick exactely like this video
In the RC and Service options everything is set to " no imput "
When I pull down the joystick the motors gets off and the red led is blinking till I release.
In the information tab I get this error : " Serial data corrupted " This, until I release the joystick... Then the motors get back to work again. ( Even when they were off in the first place )
I also got this message once : " License is not valid - This firmware can not be run in this board. Upload proper firmware(...) " And the green led started to blink fast.
I can assign the horizontal axis to any fonction. Only the vertical axis have trouble.
When I only leave the power wires I get the same stuff without the error message.
Pressing down with the joystick also always freezes the monitoring till I release...