EN RU CN
2.41 B4 PROBLEM
  • Hello,
    thank you first to be here with you.
    just for your information, i tried new firmware 2.41 B4 with a lot of settings for pid. i have
    an erratic vibration on roll axis. I spend a lot of time changing parameters and i found no solution for this.
    my system is a desire rc card 32bits 3 axis. we change the firmware by previous one, and it has fix the problem.
  • What kind of gimbal you have, if big one try setting advanced/gyro LPF to 1 or 2.
  • yes Garug,
    it is a big one, i 'll try.
    i reduced the trouble with pid settings.
    the problem is a bit the same as here
    https://www.youtube.com/watch?feature=player_embedded&v=I-B0uanIQA4
    but less important and erratic
  • Have you tried use the Camera IMU only?