I bought a carbon fiber case for the Alexmos board and it has an integrated power switch with two solder prongs coming off of it. I'm sure that this is a dumb question, but I'm just not sure and don't want to fry anything. Do I just solder the T connector wires that go to the battery to each of the two prongs and then short wires to the respective battery points on the board (like a daisy-chain)?
Here's one on eBay. If you have the board version with extension board that stacks on it, don't get it. I made it work, but there's really not enough room in the case.
This is a switch that should be connected in series to the the red wire. if you need a picture i can post it up. Just cut the red wire from your Lipo into half and solder it in between