EN RU CN
Problems in the YAW axis
  • Hello everyone

    In the TAB RC (RC control)

    ROLL Angle mode (Checked) ........ Min Angle = -30, Max Angle = 30, Intial Angle = 0

    PITCH Angle mode (Checked) ........ Min Angle = -45, Max Angle = 105, Intial Angle = 0

    YAW Angle mode (Checked) ........ Min Angle = -45, Max Angle = 45, Intial Angle = 0

    The axis PITCH and ROLL the initial angle are placed

    1) But the YAW axis is not initialized.
    2) The YAW axis rotates very slowly, without connecting the cable (RC-Y)

    Any suggestions are welcome
  • I have SimpleBGC 32 Bits board
  • I think you have to redo the calibration of the axes of the gyroscope for all 6 positions