Hello everyone

In the TAB RC (RC control)

ROLL Angle mode (Checked) ........ Min Angle = -30, Max Angle = 30, Intial Angle = 0

PITCH Angle mode (Checked) ........ Min Angle = -45, Max Angle = 105, Intial Angle = 0

YAW Angle mode (Checked) ........ Min Angle = -45, Max Angle = 45, Intial Angle = 0

The axis PITCH and ROLL the initial angle are placed

1) But the YAW axis is not initialized.
2) The YAW axis rotates very slowly, without connecting the cable (RC-Y)

Any suggestions are welcome