EN CN
No luck connecting.
  • Octopilot
    So I downloaded the GUI software and the recommended drivers and extracted them. When connected, the device is showing as FT232R USB UART. Windows refuses to recognize the drivers with a "windows could not find driver software for your device" even though I point it directly to the folder where they were extracted to... so I never actually connect to the interface.

    OS:Windows 7,
    GUI: SimpleBGC GUI v2.2 b2
    Drivers: CDM v2.12.00 WHQL Certified,
    also tried cp210VCP

    Do I need a different version of the GUI or am I missing something here? The gimbal is working properly now so I don't want to re-flash and jeopardize causing errors, since none exist now. I just want the ability to connect and tune if necessary.

    You guys seem to know what you're doing so, anyone been here?

    Thanks in advance.
  • HighImages
    Here is my set. Hope it helps.

    Windows 7
    SimpleBGC GUI v2.43 b6
    CP210xVCPInstaller x64

    When I used that it connected right up.
  • AndrewSupport
    Hello, you need download and install this driver for your OS: http://www.silabs.com/products/mcu/pages/usbtouartbridgevcpdrivers.aspx
Add a Comment