Hello my name is Patrick,

'm new to this forum and my English is not very good, I'm from Austria


But I have a hand Gimabl I have a big problem.
I get this Gimbal simply not to run. I hope you can help me. :)


So my problem:

AlexMos 32 bit controller - works so far
2x iPower GBM5208-200T engine
1x iPower GBM5208H-200T engine
1x Panasonic GH3 - Camera

But I just get this PID settings not go.
My Gimbal does what he wants, already tested verschiesene instructions.

6 axis calibration was performed
How much has this pole engine 14 is true this?



I hope you habtr a tip for me, do not go on!

Thank you very much