EN CN
Electronics dummy question
-
I bought a carbon fiber case for the Alexmos board and it has an integrated power switch with two solder prongs coming off of it. I'm sure that this is a dumb question, but I'm just not sure and don't want to fry anything. Do I just solder the T connector wires that go to the battery to each of the two prongs and then short wires to the respective battery points on the board (like a daisy-chain)?
-
*FACE-PALM* Figured it out. I typed before I thought.
-
What case did you get? Can you provide a link?
-
Here's one on eBay. If you have the board version with extension board that stacks on it, don't get it. I made it work, but there's really not enough room in the case.
http://www.ebay.com/itm/New-Carbon-Fiber-Controller-Box-Case-for-Alexmos-Brushless-Gimbal-Controller-/261440180365?pt=LH_DefaultDomain_0&hash=item3cdf0c908d -
This is a switch that should be connected in series to the the red wire. if you need a picture i can post it up. Just cut the red wire from your Lipo into half and solder it in between
Howdy, Stranger!
It looks like you're new here. If you want to get involved, click one of these buttons!