EN CN
ARMBGC V3.0 "Alexmos" Controller 3-AXI / iPower GBM5208-150T Setup HELP!!!
  • lab101
    I have a few questions for this setup. I have the ARMBGC V3.0 "Alexmos" Controller 3-AXI and 3 iPower GBM5208-150T motors. I need to know the following:

    Which battery do i need to get in order to power these motors and controller?
    Which of the three wires are (+) and (-) and the third wire is for what?
    How do i connect to the com port on a mac?

    Thanks in advance for all your insight!
  • ArmBGC
    HI.
    1. you can use 3s or 4s , for 52080 you can use 4s
    2.Black is GND, Red is 5v, White is signal from RC.
    3. you can use onboard USB for connecting to MAC.

    IMPORTANT, don't use 5wire cable if you 3-axi controller connected as shield
  • lab101
    Thank you ArmBGC,
    my motors dont have colored wires. All 3 wires are black. Also, I cannot connect to a com port on the mac when i use the USB connection. It doesn't pop up on the menu. Thanks.
  • lab101
    Basically, the Board will not detect.
Add a Comment