Hello Everyone,
this is my first post here :)

I have following problem:
When using DYS SUMMER-AIR (which suppose to have alex mos 32bit) i can control only one RC channel.
My setup consist of ProfiCNC Pixhawk2, where output to gimbal is from RC7 and RC8.
RC_Roll pin mode is set as normal.
When I set input as RC-Roll i have control over only one of axis . Changes of second input (channel) is shown as movement of white arrow on the RC Settings tab but without movement of axis I chose.

Operation Mode Selection is Angle Mode for ROLL, PITCH and YAW.

Power is from 6S battery. Motors are getting quite hot.


Board version: 3.1.
Firmware: 2.68 b5
SimpleBGC32 GUI v.2 68 b6

Any ideas why i can’t have control over second axis ?

Second question: Is there any repository with older firmware - such as 2.58 ?

Third question: Maybe You have default settings profile for this gimbal ?

Kind regards,
Maciek