EN CN
Control module not turning on
  • zack68ss
    I have a question. I have been trying to calibrate my gimbal again and the W-BGC Pro control box would turn on and beep when i would connect the usb cable. Recently it won't power up unless i turn on the battery power. Has anyone had this happen to them? Is the box toast? It still turns on and runs the motors with battery power but not without. So i can't calibrate it unless the motors are powered on.
    Thanks in advance
  • AOPEN3434AOPEN3434
    maybe your usb cable is bad
  • zack68ss
    I tried 3 different ones. It's not the cable. I used the same cable for other things and they work just fine. The usb doesn't power the control board for some reason.
  • AOPEN3434AOPEN3434
    controller my be on its way out! or you have a short somewhere.
  • zack68ss
    I think ill just buy a new board. Thank you! AOPEN3434. Any reasonable suggestions?
  • AOPEN3434AOPEN3434
    the advanced board is the one to get or hiy voltage if you can find one!
  • AOPEN3434AOPEN3434
    the Extended ( BaseCam SimpleBGC 32-bit Extended Gimbal Controller Encode ) board is the most popular .
Add a Comment