I mounted the gimbal with gopro to the quad, connected the roll/pitch to the f1/f2 pins on the naza controller and connected power to gimbal and drone. It worked great-steady as a rock no matter where I manually tilted the quad. Went into naza assistant and activated the gimbal control and now I get nothing. Even with transmitter off in the original setup the gimbal does not move. Red light. I probably messed everything up at this point by pushing the reset button on the gimbal board but it wasn't doing anything anyway. Help. All I wanted to do is use the pitch lever on the transmitter. not sure where the x1 connection comes in.