Hello,
I have recently got a 3 axis gimbal from a local reseller, which works fine, I was able to balance it properly only got one strange problem: if the frame is rotated (on the roll axis) approx 45 degree on any side, the gimbal starts freaking out, until i turn it back, and it usually stays unleveled for 10-20 sec when it actually levels itself out again, it more dominent on the left side however, and doesn't happen on any other axis.
Automatic upside down mode is disabled and it even happens in profiles without follow mode, acc is properly calibrated.
Any idea what causes it and how to fix it?

Thanks,
Andrew