EN CN
No Yaw motor, pitch and roll going spazzo
-
When I finally got connected to the gui, (what a pain), I lost the yaw motor, and pitch and roll started a violent twitch, and excessive moving around. I shut off the motors and saw on the gui that the sensor showed movement, even though there was none.
Is this board dead?
I tried all calibrations more than twice, and so I hit defaults and it got worse. Entered all the previous values back in, and still no joy, but it was not as violent. It twitches on pitch and roll, and no yaw at all, even though the gui shows movement on that axis, even when there is none.
Anybody got a clue to this one? If you do please clue me in, cuz' I'm pissed.
Thanks in advance. T. -
and it also is spitting out about 12,000 12c errors per minute, thinks it's sideways or upside down then rolls itself with no motion. I think I got a bad IMU, what do you guys at Basecam think, and what can I, (we) do about this?
-
Nevermind
Howdy, Stranger!
It looks like you're new here. If you want to get involved, click one of these buttons!