EN CN
Green Light won't stop flashing when calibrating
  • stiddy
    I have a 2 axis gimbal that was working then stopped. No longer leveling. I went in to try and recalibrate the imu. When I start the calibration the green light flashes but never stops. GUI says....calibration started....but never changes. Is this board dead?

    Thanks.
  • stiddy
    20 days not response. So much for help in the forum.
  • Garug
    You do not provide much information to start. GUI does not provide feedback of the IMU calibration process, only LED does and the calibration takes less than 30 seconds.
  • stiddy
    I had to guess. I'm assuming it's a bad IMU. I wish someone had offered that advice. It would have saved me some headache. I bought a whole new board. Got that working.
  • Garug
    But someone saying that it is a broken IMU would just been a lucky guess based on the available information. Good you got it working though.
Add a Comment