Encoder motors.

anaka

ok fond the problem....

with S-bus you have to use the "virtual channels" in the place of RC_yaw pitch roll

now all works well :D

norik

Hi
I have different problem. Gimbal is working in normal mode. I have readings from encoders on analyse tab but I can not calibrate encoders :( After "CALIB.EL FIELD" I don't get any values. All parameters stay at 0 :( Any idea what I am doing wrong ? I have AS5048AS encoders.

brain

Garug! I have a question!

We r want to upgrade our gimbal with encoder motors.
I ammplanning to buy just the ipower encoders because they fit to my ipower motors:

http://m.aliexpress.com/item/32632450033.html?productId=32632450033&productSubject=IPOWER-motor-Magnetic-Encoder-for-3-Axles-brushless-DSLR-gimbal-motor&shortkey=VzAVZjuM&addresstype=600&tracelog=wwwdetail2mobilesitedetail

I read lots of reviews about encoders that if you use them, your motors will have much more torque.

So my question is.
If i put encoders to my motors, does they will have more power?

For example i have the biggest ipower motor (110-150t) on yaw, but it is heavy.
Can i change it to smaller and have the same torque?

We r flying red camera lots of times.

Thanks
Andrew

Garug

Encoder does not directly add power, but it makes possible to use higher voltage and full power setting on GUI and this adds a lot tongue and speed and motors run cool, without encoders the motors would overheat fast with such settings that are totally ok with encoders.

So yes, you could use smaller motor with encoders and still get good torque.

AOPEN3434

I-flight encoder kits available with cover mounting plate for I-flight BGC motors i-power GBM5208H as well! will fit upgrade BG001 & BG001 pro

http://mymobilemms.com/OFFTHEGRIDWATER.CA/BRUSHLESS-GIMBALS/Gimbal-Brushless-Motor/I-flight-BGC-Magnetic-Encoder-Mount-Plate-For-GBM6208H-200T

http://mymobilemms.com/OFFTHEGRIDWATER.CA/BRUSHLESS-GIMBALS/Gimbal-Brushless-Motor/I-Power-Motor-GBM5208H-200T-BGC-Motor-With-Encoder

paologi

AOPEN3434 If you mount the encoder on the Ipower 6208 on BG001, you have to change the structure, especially the thickness of the motor cage. you have a photo montage of BG001? I would be happy if there is a way to avoid big changes on the frame gimbal. thank you

AOPEN3434

No changes needed to motor cage for encoder plate mounting.

AOPEN3434

if you get a new PRO BG001 the motor cages are larger will fit i-power, i-flight encoder 6208 motor ! For the old BG001 the motor cages need to be modified !

paologi

Hello, i have the last PRO BG001, but if i mount the encoder on ipower6208 I increase the thickness of 6.5 mm.
see the photo: https://www.dropbox.com/home?preview=BG001_motor.jpg
do You have some pictures of how to mount the encoder on BG001? thanks

AOPEN3434

you need longer M4 bolts & stand offs, spacers 5mm lager than what you got stock 35mm , shuld leave 1.5mm.

Howdy, Stranger!

Categories