EN CN
Switching Profile freaks out my gimbal
  • ptaylor999
    Has anyone had success switching profiles via a 3-way switch on their Tx?

    I have this setup, and the switch seems to be happening, but as soon as I flip the switch, my gimbal starts spinning on the yaw axis.

    I have set up this switch to change from a 1-man setup to a 2-man setup. It would be great if I could make this switch pre-flight, but my gimbal starts spinning on Yaw with increasing speed. So, at this point I am forced to connect the board to my laptop and make the switch from the the GUI, which works fine but is a lot more trouble than simply flipping a switch on the Tx.

    Any ideas out there?
  • Garug
    Sounds like Tx is not switching to the right profile. Test on ground GUI connected. after changing the switch position do GUI Read and see if correct profile is selected.
  • ptaylor999
    Thanks Garug. I'll give that a try.
Add a Comment