limon

2 month Fighting with ZeusCam. Please, help :-/
@graud, thanks. I will try.

Comment by limon April 2016 permalink
2 month Fighting with ZeusCam. Please, help :-/
@Graud, and do you know, how do manufacturer suggests I will make accel calibrations for both sensors mounted inside the gimbal? I guess I could unscrew some bolts to unmount the camera sensor, bit is seems strange. Also I am not sure if it is possi…

Comment by limon April 2016 permalink
2 month Fighting with ZeusCam. Please, help :-/
Btw, is there any chance it is a bad accel calibration? I did not do it, because I don't know, how to fix gimbal in 6 positions exactly along ground axis. Both censors are mounted inside the gimbal. But I think bad accel calibration causes wron…

Comment by limon April 2016 permalink
2 month Fighting with ZeusCam. Please, help :-/
@Garug, thank you for advises. Installation on a picture is really strange. That time I tested on VERY long ropes. They caused slow gimbal vibrations during the flight ( the whole gimbal 1-2 times a second). I also tested vith very short ropes and m…

Comment by limon April 2016 permalink
Basecam 32 (Alexmos 32). Too weak motors?
@wzbart_pl, As I understand, if your have well balanced pitch, than "pitching" will never move the center of gravity, because pitch will rotate camera around its local center of gravity and it will not affect on the centers of gravity for…

Comment by limon April 2015 permalink
Basecam 32 (Alexmos 32). Too weak motors?
Hello, wzbart_pl! You are lucky that you can put power = 180. My motors heat at this power in 30-60 seconds. The seller from China advises me to buy BGM-5208H-200T or DYS BGM-5208-200T, but now I see this may not help, because they do not look much…

Comment by limon April 2015 permalink
Basecam 32 (Alexmos 32). Too weak motors?
And one else question. Now I use ubec 12V 2A to power all gimbal. Could it be too little? Should I power from 5S? I think increasing the number of S in LiPo is the same as increasing the POWER in GUI. Am I right?

Comment by limon April 2015 permalink
Basecam 32 (Alexmos 32). Too weak motors?
Graud, I couldn't shot a video, but after re balancing it has become a little better. Now, when the gimbal is off, I can put camera in every position and it will be static. I flew indoors and there were no problems. Outside there was moderate w…

Comment by limon April 2015 permalink
Basecam 32 (Alexmos 32). Too weak motors?
Graud, I have rebalanced the gimbal and will send here a video shortly. Today I am going to check again in the air. Your help is very important. Thank you!

Comment by limon April 2015 permalink
Basecam 32 (Alexmos 32). Too weak motors?
Thank you very much, Graud, for your detailed response. I will try the first item you are talking about: there is some potential to compact the gimbal for roll motors. Also 1 cm to compact for yaw motor. Tha camera mount seems very good. I'v …

Comment by limon April 2015 permalink

Howdy, Stranger!

It looks like you're new here. If you want to get involved, click one of these buttons!

About

Username: limon
Joined: April 2015
Visits: 9
Last Active: April 2016
Roles: Member