summ

Question: where do I find CALIB.ACC in the GUI?
Did you find it? If not ... Click Calibrate IMU and in the window that comes up you´ll find what you´re looking for

Comment by summ February 2015 permalink
Gimbal starts humming and behaves strangely
Pitch and roll are both DYS BGM5208-75 motors. I had the gimbal just sit there and do its humming for about 10 mins. the motor is warm, but you can still touch it ... ambient temp is about 20 C. So I think unless I go fly in the Sahara it won´t burn…

Comment by summ February 2015 permalink
Gimbal starts humming and behaves strangely
Only time I wish I had a Mac haha. Did not find a similar analyzer for Win. At least none of such simplicity. But I´ve checked against an analyzer app for Android and tried to filter 135Hz. Still not quite there. I still get a little of that vibrati…

Comment by summ February 2015 permalink
Dys gimbal and Canon 5d mark3 with 24-105mm kit lens
hey phil7 .. have you solved your problem? I have nearly the same setup, although different lens. But mine works nearly ok. Just some vibrations left when cam is lever. Other than that excellent gimbal. So if you´re still stuck ... leave a comment o…

Comment by summ February 2015 permalink
Gimbal starts humming and behaves strangely
Hey ... after recalibrating the IMUs and recentering them on the rig (it seems the sensor itself is a bit off inside the plastic casing) the Roll drift when pitch is applied is gone. One prob solved ;) What is definitely causing humming/vibration is…

Comment by summ February 2015 permalink
Gimbal starts humming and behaves strangely
After fiddeling a bit I figured the humming is the pitch motor. I´ve turned off the others and played with the Frequence Filters, which eliminated 134Hz +/- 20. Still it reports missing steps, allthough the pitch is very responsive at higher speeds…

Comment by summ January 2015 permalink
Gimbal starts humming and behaves strangely
Yes it says motor is missing steps. Meanwhile I think the humming/vibration comes from the pitch motor. If I tilt the camera up or down the vibration goes away. Another strange thing is that even if the gimbal just sits there doing nothing it will s…

Comment by summ January 2015 permalink
Gimbal starts humming and behaves strangely
Well ... actually it responds very good to speed. Right now it´s set to 40. But sometimes the whole thing starts hummin and shakin and after that its ok for while. I´ll see about the RC limits again. What could cause the Roll to have a life of its o…

Comment by summ January 2015 permalink

Howdy, Stranger!

It looks like you're new here. If you want to get involved, click one of these buttons!

About

Username: summ
Joined: December 2014
Visits: 0
Last Active: February 2015
Roles: Member