Shutter

Gimbal shakes when first turned on until corrected by joystick-then it's stable
Just don't know at this point. I've gone though every setting, ensured balance, double checked settings and done the gimbal dance...but I still get 10-30 seconds on shake in the beginning when turned on. Only thing I've found is t…

Comment by Shutter January 2015 permalink
Gimbal shakes when first turned on until corrected by joystick-then it's stable
Okay, update... I have rechecked wiring and balance, but I still have this issue. I have turned off "gyro calibration at start", but when the gimbal is turned on, it tries very hard to roll clockwise...If I keep the joystick pointed to t…

Comment by Shutter January 2015 permalink
Gimbal shakes when first turned on until corrected by joystick-then it's stable
I will try disabling "gyro calibration at start" and report back I did perform rc sub trim, but I did it manually. Took me a while to figure out at first, since I was getting horizon drift pretty bad in the beginning. However, I have no…

Comment by Shutter May 2014 permalink
Gimbal shakes when first turned on until corrected by joystick-then it's stable
Under rc control, roll, pitch and yaw have a blue mark in each spot...is this speed mode?

Comment by Shutter May 2014 permalink
Gimbal shakes when first turned on until corrected by joystick-then it's stable
Start up procedure for me is to grab the gimbal, and place the bottom edge of it on the ground and turn it on. This keeps the camera in a stable position when turning on. After it calibrates, it starts trying to make the camera point down and roll…

Comment by Shutter May 2014 permalink

Howdy, Stranger!

It looks like you're new here. If you want to get involved, click one of these buttons!

About

Username: Shutter
Joined: February 2014
Visits: 9
Last Active: January 2015
Roles: Member