EN CN
Pendulum Effect on Yaw
  • Armando
    Hi,
    I have managed to Tune my DSLR Gimbal nicely but have what I would describe as a Pendulum Effect on the YAW axis... It feels like the motors have a dead zone... So when i move in forward the camera starts to oscillate from left to right... This is not a vibration caused by incorrect PID settings or lack of rigidity in the frame...Did anybody encounter this problem and where in the settings should i look for a solution?

    Armando
  • Garug
    Are you sure your Yaw motor inverted status is correct?

    What FW are you using.
  • Armando
    Just Checked Firmware its 2_40 b6... Just notice there is an upgrade to b7...will install it and see what happens.. I did auto detect on the motors but will try to invert it just to see what happens...will let you know the results over the next few days...Garung thanks for your advice...
  • Armando
    Nearly there...Inverted Status was correct...It seemed to me that YAW settings where to aggressive...They are a lot closer to the X and Y settings now and its getting good...Will need to tweak them a bit more but getting close...
Add a Comment