Hey there

I have the SimpleBGC Alemos board. (Perhaps I should say "had...")

I have a Futaba R6202SBW connecting a Naza 2 with SBUS. Channel 1 SBUS goes to Naza. The Rx only has 4 ports.

Connected Channel 2 from the Rx to the SimpleBGC and up came the smoke from the board...
So my first guess is power should have been disconnected from the servo wire.


So I ordered a new Alexmos board. This one: http://hobbyking.com/hobbyking/store/__53726__Quanum_Micro_AlexMos_Brushless_Gimbal_Controller_2_Axis_Kit_Basecam_SimpleBGC_.html

Im liking the size of it and hope to fit it inside of the clean section of my CineTank.

Can anyone please point me in the right direction?
Id like to continue to use SBUS if at all possible. Do I need a different Rx?

thank you very much for helping!



Additional Info if needed:
Cinetank with their new gimbal. ipower motors, 2208 and 2212. 4s setup direct to gimbal board. Naza M 2.