EN CN
When I connect my gimbal motor and turn on it doesn't recognize the sensor
-
I got 3 gimbal motors. I recently overhauled my gimbal i took everything apart and put it together again. The board and the sensor board works fine when there is no motors. It also works fine when the pitch motor is attached. However when I connect the roll motor and the yaw motor, its starts vibrating and the GUI says the sensor is not connected. I think I have tried everything now. I did try to connect the roll motor to the pitch input but I got the same result. I cant measure any faults in the motors ether. Do someone have any good answer to this
-
Was it working ok before you took it apart? Did you route the cables like they were? looking at the GUI, is there now I2C errors? It could be that IMU cable is too close to motor cables.
Could also be that you have swapped the roll and yaw motor connections or connected the motor connections inverted.
Howdy, Stranger!
It looks like you're new here. If you want to get involved, click one of these buttons!