Hi, I just powered up my newly purchased 2D gimbal and got a rapidly flashing green light and nothing else. I downloaded the GUI and the matching firmware, got connected to the board from my PC only to be told "Sensor I2C not connected" followed by hundred of I2C errors. I hit the reset button on the board a few times, powered up and down several times and no change. Does this men I have a dead board? From the GUI: Firmware 2,2b2, GUI 2.2b and Board 1.0 Regards, Bob
I'm facing the same problem about the sensor, the error shown 'sensor not connected'. But I've check the wire no problem with others connection. Pls help. Thanks.