EN RU CN
Follow mode not working on SimpleBGC 2.48b
  • I have a clone SImpleBGC board that i just updated to the 2.48b firmware. In fixed mode the gimbal runs really great. Much better than the old firmware that was on the board when I got it from eBay.

    The follow mode worked on the old firmware, but when I apply it to the new firmware, all it does is make both the pitch and roll axis lock and I can set the angles by hand and both axis stay where I place them.

    I cannot seem to figure this one out. Why doesn't the pitch tilt based on the angle I set the gimbal?

    Any help would be nice.