EN CN
SimpleBGC - "PID Controller" panel locked?
  • danielskimm
    Hey guys.

    I've bought a 2nd hand Ghost V2 gimbal recently and i've been struggling to get this thing working.

    At the moment nothing works. When i connect the battery, nothing happens so i thought i would start with the GUI first.
    The board on the system is a basecam 32bit board.

    - Im running SimpleBGC v2.40 B7 to suit the firmware as recommended by the software.
    - I've connected the gimbal to the GUI with a USB mini data cable
    - The board lights up red/green

    On the GUI, the sensors seem to be working judging by the three accelerometer diagrams however the "PID Controller" panel is completely locked and i can't input any values, when i disconnect the gimbal and restart the program, the control board is unlocked again and i am able to put in values; which confirms its only a issue when the gimbal is connected to the GUI.

    I'm completely new to this and any help will be appreciated.


  • Garug
    That is a really old FW, but anyway, make sure you use the corresponding GUI version.
Add a Comment