EN CN
Gimbal is stable during tuning but going crazy during flight
  • lamenace
    Hi,

    My gimbal is ok when I'm rolling and pitching my frame manualy but it goes crazy during flight. I'm using 8bit with latest fw
  • AOPEN3434AOPEN3434
    hello,
    sounds like vibration problem what your using ?
  • lamenace
    RCTimer 3 axis gimbal
  • AOPEN3434AOPEN3434
    what sort of vibration dampning are you using?
  • basdebeer
    I have the DYS smart 3 gimbal and have the exact same problem!
    especially yaw gets crazy in air.
  • Garug
    How do you power it? if from flight battery, try powering gimbal from the balancer port.
  • MdG_NL
    If possible, try to see in the Gui (compass sensor monitor) what happens when all MultiCopter motors are running around 70%.
    off course without Props (-:
    It's possible that these motors give some noise to your sensor/8-bit board.

    Otherwise check your power as Garug says or try to power your gimbal with a other battery.

    Regards,
    Marten
  • Lemmi
    Sounds like my problem. Will report after the testflight today with minor changes (Power setting / position of frame IMU). What kind of camera are you using?
  • anaka
    thank you guys
    i had the same problem and following your directions i made my gimbal stable

    now all is smooth also during flight

    thanks
    Augusto
Add a Comment