EN CN
Upgraded firmware and gimbal died
  • clarkaa777
    I just purchased a 2 axis gimbal for my gopro. I accidentally upgraded the firmware to version 2.4b7 and then I read I should only be using 2.2. Now my gimbal is dead and wont work or respond at all. I tried to flash the 2.2 back to it and it says it works with the GIU 2.4 but when I open the 2.2 GIU it wont respond or let me write and the gimbal just floats loose. Can someone please help me?

    Thanks

    Andy
  • newgimbal
    there are instructions in the manual for recovery. For the 32bit version you can find it on page 38 of the manual. I am not sure about 8bit. maybe it's the same?

    http://www.basecamelectronics.com/files/v3/SimpleBGC_32bit_manual_2_44_eng.pdf

    goodluck
Add a Comment