Hi. I'm a complete novice.

I bought a product recently and it has stopped working very soon after I started using it.

When I connect it to the PC, and connect with SImpleBGC, It informs me that 'Sensor is not connected'.

The product is from China and to return and recieve a replacement will take over a month.

I can see I can buy a new IMU for £13, which I would happily do if I knew it would work.

Can anyone give me any advice on how I can be certain the fault is with the IMU, and not the cable, or the connections elsewhere??

If it gives any clues - the setup gives a series of fast beeps on bootup when working properly. The same when switching between modes. SInce the problem however , I only get a single beep before the gimbal starts moving erratically.