EN CN
Aux 1, 2, 3 not showing up on CMD list box
  • ISeeIt
    (Version 3.0 32 bit Alexmos board)

    I'm trying to setup my Spektrum DX8 using the AR8000 receiver, with satellite (it only seems to work if I have a satellite connected).

    YAW, ROLL and Pitch all work fine so the Tx/Rx and binding is fine.
    I'm now trying to get my transmitter's Aux2 3-way switch to control switching between 3 profiles.
    I have a signal only wire going between my Aux 2 pin (AR8000) and the single aux2 pin (in the middle of the controller board).

    I can't find Aux 2 anywhere on the RC tab in the GUI.
    What am I missing?
  • Garug
    If I remember correctly the Aux channels are outputs.

    You should connect to some channel that is visible under CMD.

    Or you could select RC_ROLL pin mode: spectrum and connect the satellite directly to board. I have not tested this but should work.
Add a Comment